Energy Savings Plan

Your 17 Point HEATING System Check Includes:

Your 17 Point COOLING System Check Includes:

1. Test for Carbon Monoxide
2. Test for gas leaks up to furnace shut off valve
3. Check air filter, replace with home owner supply
4. Check humidifier operation, change for winter operation
5. Test and adjust operation of safety and operating controls
6. Inspect flue pipe and draft diverter
7. Monitor for combustion leaks
8. Test gas valve operation
9. Check blower motor (and belt if applicable)
10. Test and tighten all wiring and connections
11. Adjust burner for maximum efficiency
12. Clean burners and inspect heat exchanger
13. Clean and adjust thermostat
14. Lubricate all motors, bearings, fans and circulators
15. Clean and adjust pilot assembly
16. Clean flame sensor
17. Inform customer of equipment conditions

1. Lubricate all moving parts.
2. Install gauges, record pressures/temp.
3. Check air filter, replace with home owner supply
4. Measure superheat to fine tune refrigerant level.
5. Flush condensates drain to protect against overflow.
6. Clean the outdoor condenser coil
7. Check blower motor (and belt if applicable)
8. Test temp drop at return and supply air.
9. Safety test all controls for proper operation.
10. Amperage readings on all motors, test bearings.
11. Test operation and condition of compressor contacts.
12. Inspect capacitors and relays for rust and leaks
13. Tighten and test all wires and connections.
14. Clean thermostat and confirm proper operation
15. Turn humidifier off for summer non-operation
16. Check outdoor disconnect (if applicable).
17. Inform customer of equipment conditions